Select a specification to see how it affects model selection.
Check this recorded value against the target device and project requirements before quotation approval.
Filter the product record by the information needed for engineering or purchasing review.
| Fiberland Part Number | FLD-ADAPTER-03 | Vendor Name | FIBERLAND |
|---|---|---|---|
| Data Rate | 100G | Wavelength | - |
| Reach | - | Form Type | CFP |
| Optical Interface | - | DDM Support | - |
| Commercial Temp. | 0~70℃ | Industrial Temp. | - |
| Compatible Brands | Cisco,Huawei,Nvidia...200+ brands | Compliance | CE,FCC,ROHS,REACH |
| Warranty | 3 Years | Mode | - |
Cross-reference the original manufacturer part number with the corresponding Fiberland part number before confirming the target device and firmware.
Send the target device brand, model, firmware or OS and port details for an exact compatibility review.
A part-number cross-reference is a model-selection starting point, not a blanket device guarantee. Final fit depends on the exact device, firmware or OS, target port and requested coding profile.
Review common data-center, DCI, campus, server and metro-network connections before confirming speed, reach, fiber type and connector.
Compare representative network topologies and link paths to identify the appropriate product family for the intended deployment.
Follow the checkpoints used to verify materials, firmware, optical performance, temperature stability, compatibility and final inspection.
Review the sequence from material verification and firmware programming through optical, temperature, compatibility and final QA inspection.
Answers to common compatibility, installation and troubleshooting questions.
Yes. The transceivers do not normally need to be from the same manufacturer. Their Ethernet standard, wavelength, fiber type, lane configuration, reach, and other link requirements must be compatible.
Abnormal temperature, voltage, TX power, RX power, or bias-current readings may indicate an optical or hardware issue, but they can also result from incorrect calibration or communication between the compatible module and host device.
Possible causes include incorrect fiber type, wavelength mismatch, polarity, dirty connectors, excessive optical loss, incompatible link partners, FEC settings, port configuration, or compatibility issues.
Compatible modules can be used in telecom and service-provider environments when they meet the required optical specifications, environmental requirements, protocols, and host compatibility.
Reinserting a module forces the host to redetect and reinitialize the transceiver. If this repeatedly resolves the issue, inspect the port, module contacts, firmware behavior, and compatibility profile rather than assuming the optical link itself is faulty.
Move from model selection to internal approval with the documents, compatibility checks and verification paths buyers use most.
01Technical filesFind model-level specifications, drawings and selection documents before internal review.
Find datasheets
02Device fitReview device, firmware and coding fit before specifying a module for your network.
Check compatibility
03VerificationSee optical, functional and pre-shipment checks used to verify product performance.
Review testing
04Project approvalReview certification routes and request supporting documents for project approval.
View documents